Garden Tractor Forums banner

Discussions Showcase Albums Media Media Comments Tags

1-6 of 6 Results
  1. MTD Tractor Forum
    I have a 2015 Troy Bilt Super Bronco that I use to mow about 1+ acre. The area has many trees, garden/flower beds,etc. The steering, especially at slow speeds, is difficult to turn. Has anyone developed a poor man's power steering or lower drag for turning? I once read about using roller...
  2. John Deere Tractor Forum
    Does someone have the part numbers from JD for the front wheel bearings on a 1964 round fender? Thanks
  3. Massey, Snapper, AMF Tractor Forum
    Massey Ferguson MF 12 mower deck blade spindle assembly repair in progress. See the attached pictures. Is this salvageable or do i need to just replace it as a whole? Does anyone have an assembly they will part with?
  4. Bolens Tractor Forum
    Evening All, I had to remove my PTO on the 1220 because the small Torrington bearing next to the pulley failed,this I think is a poor design on a otherwise great PTO there is a large roller bearing at the front for the Snowcaster but the belt load and mower deck is supported by a bearing which...
  5. Bolens Tractor Forum
    Morning, Other than the G10 PTO only has one belt is the PTO itself the same ? Just a different single pulley I,m thinking ? Wondering why in the PTO did Bolens use 2 different size bearings,the smaller Torrrington got beat up bad with the heavy slush type snow while the larger is fine. Thanks...
  6. Allis Chalmers, Simplicity Tractor Forum
    I just got a 1980 9020 Tractor with rear power take off and I need to replace the bearings and bushings in the clutch pivot arm. Does anyone have ideas on how to best remove the bearings and bushings? The bearings are seperated by a spacer and there is no room to insert a puller. I hope...
1-6 of 6 Results