Garden Tractor Forums banner
carb

Discussions Showcase Albums Media Media Comments Tags

1-12 of 13 Results
  1. Case, Colt, Ingersoll Tractor Forum
    Man I really im banging my head against the wall with this tractor and could use some guidance. My grandfather gave me his old Case 448 18HP Onan garden tractor as I thought it would be a great fixer upper. So far I replaced the following... - New Battery - New Plugs, coil and spark plug wires...
  2. Mechanical & Hydraulics Forum
    I got this power washer for 40 dollars. It never ran consistently and the previous owner told me it needed a new pump. So I re[placed the pump and it would still stall sometimes, so I replaced the gas cap to eliminate a possible vacuum. It still had problems, so I replaced the carburetor, the...
  3. Sears, Craftsman Tractor Forum
    Sorry, I am new here! I recently purchased a GT 18 I don't know a whole lot about it. Before i purchased it sat for quite sometime, it does have some carb issues. I was wondering if anyone sells them new or if they are worth rebuilding? Thank you for your time! Model #917.257112 Onan Engine #...
  4. Bolens Tractor Forum
    had a though that someone else might have had this same issue and same thought process and may have already found a good solution my cousin and I bought a pair of old bolens a couple years ago. We're pretty mechanical, however, these pre-date us by a few years. I took the 650, he took the...
  5. John Deere Tractor Forum
    Had to replace a broken choke shaft. Easy job, but I didn't get any pics of the choke and throttle link orientations. The link rods are different shapes and lengths and it would be great if someone had, or could take, a few pics of the rods installed. It was painful enough to pay $25 for a...
  6. Sears, Craftsman Tractor Forum
    Hey guys new to the forum. I have a Craftsman gt18 with the 18hp Briggs on it. The fuel pump seems to be working, but it wont run. If you pull the fuel line going into the carb and put it in the choke hole on top, it will run. I've took it apart and put fresh gas soak for an hour or so, just to...
  7. Parts
    i have A T-13 that needs a new carb...any leads?
  8. Sears, Craftsman Tractor Forum
    ST16- new head, carb rebuild, now starter is making god awful noises and won't stay running unless full throttle. Bought her in "working" condition, but missing a carb needle (ha, ha Ha). Ordered parts, had a friend put together, then needed new gasket set (exhaust leaks) new head (exhaust...
  9. Power Equipment Forum
    I had the chainsaw out today taking down a dead tree for my neighbor next door. While it initially ran well, it began to acted starved for fuel, but would restart after it died. Opening and resealing the fuel cap didn't correct the issue. It almost seemed that position was key at first, as it...
  10. Bolens Tractor Forum
    I've had trouble with my Bolens 1250 running erratically for a few months. I've adjusted the carb and run cleaner through it. I found oil in the points box and cleanned and polished that. Today I had it running good for a while the it started running poorly again. It farts black smoke seconds...
  11. Mechanical & Hydraulics Forum
    This troubleshooting guide may help: http://gardentractortalk.com/forums/files/file/4177-troubleshooting-two-piece-flo-jet-leakage/
  12. Mechanical & Hydraulics Forum
    I'm rebuilding a carb on a B & S off my Big Ten. The carb was very corroded. I soaked it in a vinegar and water solution. This cleaned it pretty good. The float valve was stuck in its guide. I pulled but the head broke off. I'm considering drilling it out but am afraid of collateral damage. The...
1-12 of 13 Results
Top