Search Results for ‘ignition’

New to the forum here. But you guys seem to have a vast amount of knowledge so I will ask the question My GT19 has had electrical issues since I picked it up in '95. Most of them I've been able to deal with until this latest one popped up. I had to tear down the tractor to repair the PS...

Are all spark plug wires created equal for a Kohler K361? I had the cowlings off of the K361 engine on my 1618 and misted some cleaner/degreaser to clean things near the spark plug (with the engine running) and the engine died. I looked closer and the wire and boot are cracked and have seen...

Hello there, I don't have much experience working on chainsaws and was wondering if a standard spark plug style spark tester would work in shecking for spark? This saw is only a season old and has been taken care of extremely well. It will not run this season not even a sputter, I am assuming...

I recently acquired a Wisconsin S8D, new - NOS - Never run! Sweet deal!! The engine runs fine (of course), however it has an intermittent "sputter" or misfire which is more pronounced at higher rpm's. Would a worn out (aged) points condenser cause this? I cleaned the points and set the gap for...

I have an old 86 John Deere with an Kohler k301. A few weeks back I rebuilt the engine. When I pulled the engine I didn't mess with any electrical. After rebuild I put the engine back in and tried to fire it up, nothing. Discovered the starter wasn't kicking out, just spinning, replaced the...

Hello, I just picked up an old gardener with a Briggs engine (not sure of the hp, no ID tag) and it has no spark. I have pulled the flywheel and everything looks good but I have no idea what to do try and get it to fire and I don't want to tear it apart and screw things up, can anyone help me ...

just picked up a 67 super 12 I need to redo all of the wiring. does anyone have some type of electrical scmatic for it Thanks ~Ben

I started my Gravely today and she ran for a bit then died. Nothing through the regular circuit. Now I suspect the switch. Is there any way of testing it?

I am thinking of putting a electronic ignition of the Onan, 1980 model. If I put the magnet for the trigger on the flywheel will it work? The thing would fire every cycle. Is there a post where this has been done? Thanks Mike

I was inspired by the work I've seen others accomplish on this site. After two years in the garage, I finished disassembly and cleaning my son's BIG TEN engine on Sunday. The gas tank, flywheel cover and backing plate were rotted through. I have a blown 23D that I am using for parts. I started...

I killed the ignition coil today in my Bolens 1253 with the Tecumseh HH120, does and one have a replacement SSI for the old Tecumseh p/n 610906. I have started searching the internet and the deep depression is setting in as I realize how difficult and costly it is to replace this part. If anyone...