Search Results for ‘magneto’

I'm trying to locate a magneto for a Tecumseh engine in a friend's Troy Bilt Horse Tiller. This is the 1st Generation TB Horse, without the PTO disconnect, etc. I believe the engine is original to the tiller. It has factory electric start. The number stamped into the shroud is a little hard...

Hello to all. New here and new to owning an old Gravely. I have an 8162B with the 16h Briggs. It had a fried coil when I got it, which I replaced the other day. The machine fired up after the new coil was installed. It ran rough but it ran. Next day it would barely start but finally did with a...

Hey all, I'm really having trouble setting the edge gap on my '66 MF-10. It's a magneto ignition engine with S/G. I believe that to set the edge gap for the coil / magnet on flywheel I must leave a .020 gap from the first pole of the coil. The points are supposed to begin opening at this time...

I was inspired by the work I've seen others accomplish on this site. After two years in the garage, I finished disassembly and cleaning my son's BIG TEN engine on Sunday. The gas tank, flywheel cover and backing plate were rotted through. I have a blown 23D that I am using for parts. I started...