Garden Tractor Forums banner

Discussions Showcase Albums Media Media Comments Tags

1-5 of 5 Results
  1. Mechanical & Hydraulics Forum
    I have a question...maybe be a simple one to answer, but as I don't have all that much experience with the small engines, it would be good to have your expert advise. I have a briggs 10hp on an Allis B-10. It ran fine after I put new points, a new plug, ignition coil, starter switch and...
  2. Massey, Snapper, AMF Tractor Forum
    Hey all, I'm really having trouble setting the edge gap on my '66 MF-10. It's a magneto ignition engine with S/G. I believe that to set the edge gap for the coil / magnet on flywheel I must leave a .020 gap from the first pole of the coil. The points are supposed to begin opening at this time...
  3. Off Topic
    For the last few years I have been amassing Magnetos, carburetors, gear boxes, Economy transmissions, etc. to rebuild and sell on line to stay busy and earn a little extra "mad" money. I have been on line finding rebuild parts like points, condensers, bearings, gaskets, any and all parts needed...
  4. Mechanical & Hydraulics Forum
    Some probably seen the thread on the Bush Hog HD-12 where I found a Kohler K341 to do an engine swap with. Got everything swapped and once I had it running realized the governor wasn't working. I pulled the engine apart and found the governor gear wasn't on the shaft. Almost like someone pulled...
  5. Allis Chalmers, Simplicity Tractor Forum
    I am thinking of putting a electronic ignition of the Onan, 1980 model. If I put the magnet for the trigger on the flywheel will it work? The thing would fire every cycle. Is there a post where this has been done? Thanks Mike
1-5 of 5 Results