Garden Tractor Forums banner

Discussions Showcase Albums Media Media Comments Tags

1-9 of 9 Results
  1. Garden Tractor Forum
    Full disclosure: I'm somewhat new to tractors, and very new to points I ignition tractors. I just picked up a couple Bolens tube frames, a 1050 and a 1054. I drove past the city they were born in on the way home and was tempted to take a pic, lol. Both tractors have no spark. On the 1050 I...
  2. Bolens Tractor Forum
    I just got a Bolens G12 XL lawn tractor and have decided to fix it up. the issues are the following. 1.) has e start but will not crank over unless the battery is hoked up directly up the the engine. (Tecumseh 12HP) I'm assuming that this is just due to broken wiring but I have never worked...
  3. Allis Chalmers, Simplicity Tractor Forum
    Struggling to get engine running on my B-110. Won't fire up. Looks like I have a weak spark issue. Not wanting to pull the engine if I don't have to, so, I'm looking into getting an external coil to solve the problem. I'm not sure if it will work with the NOVA ignition module that is...
  4. Bush Hog Tractor Forum
    not getting spark from points.changed condenser,filed points,no spark.what do I do next,
  5. Gravely Tractor Forum
    Having problem getting gravely to fire.Shaft coming out of motor is not turning magneto.Any advice.Thanks
  6. Gravely Tractor Forum
    Hello to all. New here and new to owning an old Gravely. I have an 8162B with the 16h Briggs. It had a fried coil when I got it, which I replaced the other day. The machine fired up after the new coil was installed. It ran rough but it ran. Next day it would barely start but finally did with a...
  7. Sears, Craftsman Tractor Forum
    We recently got a 1971 Sears hydro trac 14 and have been working on it for 4 days now and cannot get anything out of this engine. The engine is Briggs and Stratton 14 hp single cylinder model 320421 type 0132-01 code 7009301. We have completely taken apart the carb numerous times and cleaned it...
  8. Mechanical & Hydraulics Forum
    I have a question...maybe be a simple one to answer, but as I don't have all that much experience with the small engines, it would be good to have your expert advise. I have a briggs 10hp on an Allis B-10. It ran fine after I put new points, a new plug, ignition coil, starter switch and...
  9. Mechanical & Hydraulics Forum
    Should this be done if the plugs are clean? Or should they be replaced every (Insert hours) and the old ones tossed instead of cleaning for the next change?
1-9 of 9 Results
Top