Garden Tractor Forums banner
1 - 10 of 10 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I have a Bolens 1600H and just purchased the 18322 tiller to go with it, unfortunately looks like I'm missing a few things, brackets that mount to the tractor, cable to lift the tiller and the drive shaft. Any Ideas on where to find these? New to the site and just looking for some help, thanks
 

·
Super Moderator
Joined
·
14,167 Posts
Welcome to GTTalk. I'm not a Bolens guy but there are plenty here to help. I would try contacting some of our site sponsors to see if they can help you.
 

·
Bob's Lawn and Garden LLC
Joined
·
2,183 Posts
I have a Bolens 1600H and just purchased the 18322 tiller to go with it, unfortunately looks like I'm missing a few things, brackets that mount to the tractor, cable to lift the tiller and the drive shaft. Any Ideas on where to find these? New to the site and just looking for some help, thanks
Let me take a look and see if I have the parts you need.
 

·
Registered
Joined
·
602 Posts
I have a Bolens 1600H and just purchased the 18322 tiller to go with it, unfortunately looks like I'm missing a few things, brackets that mount to the tractor, cable to lift the tiller and the drive shaft. Any Ideas on where to find these? New to the site and just looking for some help, thanks
Do you know if you have the 18318 PTO Kit that's required for this tiller?

Looks like this.

3731908.jpg
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #5 ·
Do you know if you have the 18318 PTO Kit that's required for this tiller?

Looks like this.

3731908.jpg
Yes I do have the PTO, end of my shaft that came with the tiller a purchased does not fit this PTO, the other end does fit the tiller so I'm thinking that the tiller was use on another tractor?
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #7 ·
Let me take a look and see if I have the parts you need.
Thanks, any help would be great, looks like I need 2 brackets 1733855 and 54 left and right and then need to figure out the drive shaft issue, not sure if it is the correct length or not until I get this tiller mounted to the tractor. Also need a lift cable 1734193, I have the hydro so I don't think I need that pulley that I see in the manual?
 

·
Bob's Lawn and Garden LLC
Joined
·
2,183 Posts
Thanks, any help would be great, looks like I need 2 brackets 1733855 and 54 left and right and then need to figure out the drive shaft issue, not sure if it is the correct length or not until I get this tiller mounted to the tractor. Also need a lift cable 1734193, I have the hydro so I don't think I need that pulley that I see in the manual?
Took a look and do have the cable and brackets new. It would be best to call or send a pm.
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #9 ·
Took a look and do have the cable and brackets new. It would be best to call or send a pm.
Will do, working on another deal to get all of the parts needed on a tractor with a blown motor, hopefully that works out but if not I will call.
 

·
Registered
Joined
·
602 Posts
Shaft should be 50 5/16" long. It also cross references to the Troy-bilt GTX's tiller #18322R. May find a shaft that way.
 
1 - 10 of 10 Posts
Top