[KennyP]

Today I got the new starter for the M18 I got at the show.

Now to put it on and see what condition the engine is in. First off will be checking spark and compression. Then add a spritz of fuel to the mix to see if it will fire.

 

[Texas Deere and Horse]

Waiting to hear on the results. Good Luck!

 

[KennyP]

Since the PO had pulled the heads to check in there, I will make sure they are torqued right for now. If it runs good, then I will be ordering the new head gaskets!

 

[KennyP]

It Lives! Poured some fuel down the carb and she fired off! Didn't run long as I don't have a tank hooked to it, yet!

 

[superaben]

You can't beat a Magnum, Kenny!

Ben W.

 

[CRFarnsworth]

:thumbs:

It Lives! Poured some fuel down the carb and she fired off! Didn't run long as I don't have a tank hooked to it, yet!

Way to go Kenny! :thumbs: :thumbs:

 

[KennyP]

I was at Harbor Frieght and found on of these. It will make moving the engine around easier. I hope to put it on there today. Have another part I want to put in between, so pics will be taken.

 

[KennyP]

Here's the completed engine stand/move dolly.

 

[Auburn David]

Thats the same engine I have on my little Frankenstein tractor!

 

[KennyP]

I hope to get this installed in a tractor before too long.