[chieffan]

Looking for a manual for the LF front blade 19904-01. The 2nd and 3rd numbers are hard to read and either one could be an 8. Did not find a manual in the manuals section for anything close to that. Tractor is not running just yet and have a blade and wondering just how it is supposed to attach and if I even have the right parts.

 

[WrenchinOnIt]

Maybe these will help , pic #1 are the frame mounts where pic#2 slide up in between and the clevis pin slides thru all and allows pivot movement plus secures it to unit. Pic#3 are your lift rods and they attach to your rockshaft which allows lift and down pressure via your hydraulic lift cylinder.There are two sets of ears on your rock shaft as you stroke the cylinder you will see how the rockshaft rotates and will pivot the blade via the mounts , attach to the correct set of ears that allows said movement, ( I believe it's the rear most set of ears)

 

[chieffan]

Thanks much. I was trying to figure out how the lift rods worked. I took them off before i removed the blade from the trailer and forgot just where they went. Believe it or not all the pins are still with the blade. Need to make a new swivel lock as the old one was chewed up bad, twisted and bent sideways. That blade had some rough use. Replaced the swivel bolt right off.

 

[LPBolens]

Looking for a manual for the LF front blade 19904-01. The 2nd and 3rd numbers are hard to read and either one could be an 8.

The 54" blade that Bolens sold for the early LF's was model #18054. Maybe that is what you have.

 

[chieffan]

That is very possible the number. Tractor is a '71.