Garden Tractor Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
416 Posts
Discussion Starter · #1 ·
I have a few parts removed from a Briggs 16hp engine which I believe was once in an MTD 990 style tractor. There are two pulleys. One pulley has a large chip out of it. The other has good v-grooves. It was setup for a roll pin to go through it and I am not sure how much wear there is in the pin hole bore. Keyway is good. All you see in the pictures for one money. $20 plus shipping.
 

Attachments

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top