Garden Tractor Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Hi, I've seen early HT plans (18010) for a DIY 3 point hitch. Does anyone have plans for fabbing a 18086 3 point hitch for my HT-20?

Thanks in advance,
Jon
 

·
Registered
Joined
·
1,837 Posts

·
Registered
Joined
·
773 Posts
Not a bad price.. Steimmy.. I made mine for a 1447 and the time,, material,, and getting it to work.. I think I would have been just far enough ahead to buy one..
 

·
Tractorholic
Joined
·
988 Posts
The support blocks that are used in the end of the frame rails on the later Large Frame tractors seem to be the stopper for most folks. I have never actually seen one personally, but I understand that Sam's Bolens has a reproduction version of the 18086.
 

·
Got Sum
Joined
·
1,221 Posts
The support blocks that are used in the end of the frame rails on the later Large Frame tractors seem to be the stopper for most folks. I have never actually seen one personally, but I understand that Sam's Bolens has a reproduction version of the 18086.
Someone here or over on MTF fabbed up a set for the Large Frames by welding flat stock with the proper sized bushing thru it ,pretty sure it was a MTF post.

Here's something : http://www.mytractorforum.com/18-bolens-forum/165009-large-frame-18086-3pt-hitch-dimesions-needed-cad-model.html

Member here Classic Bolens has a set on eBay for sale : http://www.ebay.com/itm/2-NOS-Bolens-1724409-Pivot-Shaft-Supports-for-18086-3-Point-Large-Frame-HT-/331734915741?hash=item4d3cf11a9d:g:VisAAOSwUdlWclk7

Also here or on MTF there were a couple complaints about the ones from Sam's as far as fitment, not to be casting aspersions Sam's stuff is legit, but I'd certainly research and inquire.
 
1 - 6 of 6 Posts
Top