Garden Tractor Forums banner
1 - 2 of 2 Posts

· A Little Off Plumb
Joined
·
9,906 Posts
If you have access to a metal lathe you may be able to make your own mount using two (or more) hockey pucks. The pucks could be turned on a metal lathe to the correct sizes (thickness and OD) - a trick secret to machining rubber is to place the rubber in a freezer for several hours so it is frozen before machining it. Make the two halves so their total thickness plus the center plate is equal to the thickness of the center sleeve length. Bore or drill the pucks in the center for the inside metal sleeve and then assemble with the center plate sandwiched between the two pucks. The pucks can be glued together using contact cement if desired. Just a suggestion if you cannot find a replacement.
 

· A Little Off Plumb
Joined
·
9,906 Posts
Looking good - every step done is one step closer to the test drive.
 
1 - 2 of 2 Posts
Top