Garden Tractor Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2,851 Posts
Discussion Starter · #1 ·
Hi all, this winter I'm going to replace the worn spindle bushing with new, (I have the bushings) been thinking that replacing the spindle thrust bearings might also be a good idea, I've searched some but haven't found a generic bearing number for the PK numbers Old number is B24 newer number is 80-0024 anyone have a number that I can go to the local bearing store and get a couple?
 

·
Getting Out!
Joined
·
8,215 Posts
I see you on other forum, but have maybe found a number. This is hand written note I had in stuff.

Timken T 113

Hub seals National 205005

Wheel bearings NSK LM11949

Also found McMaster-Carr receipt

Steel ball thrust bearing for 1-1/4" shaft, diam 2-11/32 OD, Sheilded 60715k27 there number $20.53, but old price from 2008.

Aloy Bronze sleeve for 1" shaft, 1-1/8" od, 4" length 6381K18 Must have cut them then? Don't recall.
 

·
Registered
Joined
·
2,851 Posts
Discussion Starter · #4 ·
Hi GL thanks that's what I was wanting to learn, I'll give those numbers a try.

I was looking at some photos of your TC / MM nice looking tractor and the BG is also nice.

Thanks again
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top