Garden Tractor Forums banner
1 - 2 of 2 Posts

·
Homelite Owner Extraordinaire
Joined
·
3,175 Posts
Discussion Starter · #1 ·
for you repair gurus out there. While exploring my nephews new property I split the oil tank on my Polaris 400 Sportsman. It split after I drove up on a small tree. There is no guard around it and it hangs on the frame right behind the left front wheel. It is a plastic tank and is glued together. I have finished splitting the tank and it is not broken, stretched, or warped. The two halves are fitted together with one side having a female side and a male side on the other. In other words there is a grove on one half and a tongue an the other half. I tried the Gorilla Epoxy and it will not adhere to it. I've seen the Locktite epoxy - binder but not sure if this will work. Wondering if you guys have had any good experience with something like this. A new tank is $ 256 list and my cost of $ 149 + tax. It does have pressure on it but I can't imagine it would be that much. A regular auto engine normally carries aprox. 60 - 70 psi. Thanks for any info on this. Roger.
 

·
Homelite Owner Extraordinaire
Joined
·
3,175 Posts
Discussion Starter · #7 ·
I called the dealer where I got the ATV from and explained about the Aluminum oil tanks on EBAY. He advised that I not buy one and use it. Two reasons. #1. The fitment is wrong and the piping is wrong. #2. although it may work it does not have the correct passages and "compartments" (if you will) inside the tank. He has seen others try this and the engine failed.

He also suggested not using a glue to try to put the tank back together. Some hold well until the come in contact with the hot oil and then it breaks down and causes leaks.

I'm at a loss right now. I don't have the money for the new tank but I guess I need it.

I told him that I was going to build a shield around the front of the tank when I put it back on. He thought that was a good idea however he suggested that I make sure there is plenty of room for free air to pass by to help cool the oil. That make s sense and a I told him that I would also drill some small holes in it to help cool the oil. I don't want to take away from the purpose of the shield, so I am thinking of making the shield with some beads down it to give it strength. My neighbor has been doing some figuring and has said it can be done with a bead wheel. His son has one down state and he will be willing to run it for me when I get the steel ready for welding.

Just some more to do on the old list. Thanks for the help. I think I will still try to fix the old tank and try it. I will just have to keep an eye on it.

I will have some pics of the old tank later today.

Roger.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top