[LPBolens]

One of the attachments that I have for my Power Ho Deluxe is the 30 inch sickle bar (A302 B 01). I have everything for it except the divider rod (#1701062) that gets mounted to the far right end of the sickle.

Does anyone have an extra one of these, or could provide the dimensions so I could fabricate one?

 

[Husky]

Here is a picture of mine. It is the same as yours (I believe) Is there something here that you need measurements on? Mine look bent I guess they are not correct according to the parts list??

 

[LPBolens]

I need the length and diameter measurements for the dividers that are mounted to the ends of the bar, and close-up pics of how they are attached to the bar. Thanks in advance!

 

[Bolens 1000]

That would be good info to post as most of these dividers are missing!

Mine are all gone as well

 

[Texas Deere and Horse]

I need close-up pics of how they are attached to the bar. Thanks in advance!I need the length and diameter measurements for the dividers that are mounted to the ends of the bar, an

They appear to be attached with cotter pins from what I see?

 

[LPBolens]

From the parts diagram, I thought maybe they were attached with a small bracket directly to the back edge of the bar itself.

 

[Husky]

I need the length and diameter measurements for the dividers that are mounted to the ends of the bar, and close-up pics of how they are attached to the bar. Thanks in advance!

Are you asking for measurements from mine? I'm not sure if mine are original as the manual shows them different. I think mine are on by cotter pins too.

 

[LPBolens]

Are you asking for measurements from mine? I'm not sure if mine are original as the manual shows them different. I think mine are on by cotter pins too.

Yes, I would like to have measurements from yours, as well as close-up pics of how they are attached to the sickle. Even if by cotter pins.

 

[Husky]

Ok will do. I'll see if I can get out there tonight after work on tomorrow morning.