Garden Tractor Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
2,843 Posts
Discussion Starter · #1 ·
Hi all, well the grass has slowed to a crawl the days are getting shorter so thought I'd get the dozer blade assembly in the shop and check it over. The hitch is in pretty condition just replaced the rusty cotter pins with hair pins found some spacers and 1" washers and replaced the lift pivot pins/bolts, now for the hard part I didn't get the blade attach plate (am going to call the fellow and see if its laying around his place) in case he doesn't have it I'll fabricate one in that case I need some measurements. Its number 3 in the parts breakdown if someone could provide me with: A: the thickness of the plate B: the width of it C: total overall length. I know its 12" from the main pivot to the locking latch.

View attachment dozer1.pdf Wood Wheel Automotive tire Machine tool Gas
Wood Engineering Composite material Gas Table
Wood Gas Machine Engineering Auto part
 

Attachments

·
Registered
Joined
·
2,843 Posts
Discussion Starter · #4 ·
Hi all, well I call the fellow I bought the tractor from and he knew what I was asking about and was 90% sure he knew where it was said he check and call me back, well after dinner when I went back to my shop there was a message saying he found it and where it was in case he was gone when I got there, I took off and got to his place and the plate was where said it would be OH Happy day. Yesterday I worked on reconditioning the dozer assembly then cleaned it up and painted it today. Looks good now its to reassemble it, need to find a couple of springs for the blade trip and to fabricate a lift rod.

Wood Bumper Automotive tire Automotive exterior Gas
Wheel Vehicle Tire Automotive tire Motor vehicle
Motor vehicle Gas Machine Engineering Automotive exterior
Wood Automotive design Flooring Floor Hood
Wood Rectangle Wood stain Hardwood Tints and shades
 

Attachments

1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top