Garden Tractor Forums banner

1 - 5 of 5 Posts

·
Member
Joined
·
1,206 Posts
Discussion Starter · #1 ·
I think that the QT/S series tiller shaft will fit on a large frame correct? I believe that the difference is the length of the tiller shaft? Thank you for any thoughts on this.
 

·
Registered
Joined
·
483 Posts
Q series shaft is about 1/2" shorter over all than the one for my HT23. Both have 15 tooth couplers. Paul
 
  • Like
Reactions: Husky

·
Member
Joined
·
1,206 Posts
Discussion Starter · #3 ·
Thank you Paul. With that said a telescoping shaft on a large frame should work fine on a Q series with a tiller as it is missing the drive shaft.
 

·
Registered
Joined
·
483 Posts
Thank you Paul. With that said a telescoping shaft on a large frame should work fine on a Q series with a tiller as it is missing the drive shaft.
I've never seen a two piece tiller shaft, but like the concept. Would have to be fastened at both ends, rather than floating at the tiller end, right? Paul
 

·
Member
Joined
·
1,206 Posts
Discussion Starter · #5 ·
Hi Paul,

Yes, the end to the pto has the factory quick connect on it. The other end has two set screws and works quite well. It was built and balanced I did not manufacture this one myself.
 
  • Like
Reactions: Paulgo
1 - 5 of 5 Posts
Top