Garden Tractor Forums banner
1 - 1 of 1 Posts

1,509 Posts
Tire Wheel Land vehicle Motor vehicle Automotive tire

Here is the plans for my sleeve hitch I built for my Ford LGT 145 along with some pictures.

The frame is 2" wide 1/4" thick stock, The pin locations are made from 3/4" steel tubing that has a inside diameter of 5/8".

Below are the attached plans for the sleeve hitch.
Slope Rectangle Parallel Schematic Building

  • MH81, boyscout862, TomLGT195 and 3 others have said thanks
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.