Garden Tractor Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
549 Posts
Discussion Starter · #1 ·
Gents,

I picked up a Snapper snow blower with some other stuff and am trying to figure out what it is supposed to fit. It is a model 82099, is a two stage, and is 30" wide. The tag says it was made by McDonough Power Equipment in Texas.

It is unused, but has sat outside, although it not seized up.

It looks well built, but at only 30" wide, I'm trying to figure out what to put it on. I'm a big fan of redundancy in snow blowers!

Thanks,

Doug
 

·
Registered
Joined
·
549 Posts
Discussion Starter · #4 ·
I found a few references to it. Looks like it may have been made for the rear engine riding mowers.
attachicon.gif
82099.JPG
Thank you!

That would explain why it didn't get sold by the dealer. I can't imagine there being a high demand for something like it around here!

Regards,

D.
 
1 - 5 of 5 Posts
Top