Garden Tractor Forums banner
1 - 10 of 10 Posts

·
Tractorholic
Joined
·
492 Posts
Discussion Starter · #1 ·
I am putting a electric power lift on my MF10 and there is a switch that raises and lowers it. I am not sure where it goes. I would assume the installtion instructions would have told you where to drill the hole. I would guess it went on the dash or down on the plate by the hood latch. I saw a photo of a MF10 on this site the other day with a hole in the dash to the left of the steering wheel and down a little. Does anybody know for sure?
 

·
Senior Member
Joined
·
4,482 Posts
I am not sure of the correct location but I am sure someone will be by shortly with the answer.
 

·
Tractorholic
Joined
·
427 Posts
I have a mf12 that originally had the electric/hydraulic lift. The electric pump/lift cylinder were missing and replaced with a manual lift handle before I got it but the control switch and solenoid are still there. Here's some pictures of my dash/switch. Hope it helps. I would love to see some pics of yours when you get it set up, I've never seen a complete power lift on a mf10/12.

Steering wheel Motor vehicle Grass Steering part Gas
 

Attachments

·
Tractorholic
Joined
·
492 Posts
Discussion Starter · #5 ·
Broken2 that is what I needed, thanks. Can you tell me where the solenoid is mounted?
 

·
Electric Tractors
Joined
·
5,639 Posts
broken2 said:
I have a mf12 that originally had the electric/hydraulic lift. The electric pump/lift cylinder were missing and replaced with a manual lift handle before I got it but the control switch and solenoid are still there. Here's some pictures of my dash/switch. Hope it helps. I would love to see some pics of yours when you get it set up, I've never seen a complete power lift on a mf10/12.

View attachment 27228 View attachment 27229
As soon as I saw these pictures I knew I seen that "up dwn" decal before, looked around at my old Massey parts in the garage and found this.

Wood Gas Rectangle Hardwood Recreation
 

Attachments

·
Tractorholic
Joined
·
3,097 Posts
DanP said:
I am putting a electric power lift on my MF10 and there is a switch that raises and lowers it. I am not sure where it goes. I would assume the installtion instructions would have told you where to drill the hole. I would guess it went on the dash or down on the plate by the hood latch. I saw a photo of a MF10 on this site the other day with a hole in the dash to the left of the steering wheel and down a little. Does anybody know for sure?
Hey Dan, how about some pictures and some information about what you are installing.
Howard
 

·
Tractorholic
Joined
·
492 Posts
Discussion Starter · #8 ·
@HowardsMF155 Check out my thread on "MF10 restoration" I have the whole story there.
 

·
Tractorholic
Joined
·
427 Posts
MH81 said:
Hey Dan, could you do me a favor?
Could you measure left edge of the dash and bottom of the dash to center of the hole.
That would let everyone know where to drill the hole to mount it.
I'll get some measurements when I get home from work tonight.
 

·
Tractorholic
Joined
·
427 Posts
DanP said:
Broken2 that is what I needed, thanks. Can you tell me where the solenoid is mounted?
I'll get some pics of the solenoid tonight.
 
1 - 10 of 10 Posts
Top